Fig. 1
Fig. 2
Fig. 3
277VAC
INPUT
120VAC
INPUT
GREEN
GROUND WIRE
BL
AC
K
W
HI
TE
O
RA
N
G
E
400WX Series
Installation Instructions
XXXXXXXX R
EV 1 - 07/23
2
800-533-3948 www.barronltg.com
Ceiling (Fig. 4) or Side (Fig. 5) Installation
1. Open EXIT panel from the housing and remove the hole plugs from the top (or side) of the housing, if necessary.
(Fig. 1)
2. Remove the proper directional chevron(s) from the EXIT panel(s) carefully, if necessary.
Note:
Carefully remove knock outs only, otherwise it may cause damage on the suface.
3. For Double Face:
a. Remove the back plate from the housing by removing housing screws (4 pcs) at the corner of the Exit housing.
b. Then assemble the additional EXIT panel using the housing screws (4 pcs) with the housing.
Note:
The additional EXIT panel does not have any clips.
4. Secure canopy to the housing using hole numbers “2" and “3" on the canopy with provided canopy screws ((2) #
10-24 screws).
5. Feed AC supply leads through top (or side) hole on the housing and the crossbar, then make the proper supply lead
connections. If using 120VAC, connect the black and white leads to the building utility. If using 277VAC, connect the
orange and white leads to the building utility. Cap off unused wire. If the unit is self-powered, be sure to snap battery
connector together. During installation, use the enclosed ”holding wire” for assistance. (Fig. 2)
6. Push excess wire into junction box and align holes in canopy with those in crossbar. Using screws supplied, tighten
canopy to crossbar so that the canopy is securely fastened and tight against the ceiling (or wall).
7. Snap EXIT panel back into the housing, bottom first then top. (Fig. 3)
