STEP 8 //
If choosing not to use the LED fog lights, install
the (2) mesh grille inserts into the bumper using the (2) M6
flat washers, lock washers, and nuts.
STEP 6 //
If equipped re-install the factory reverse sensors w/ the rubber
grommet flush to the outer face of the bumper. **Note: The factory trim
bezel does not get re-used. Using the supplied 4mm screws to apply slight
pressure to either side of the sensor. Over tightening of the screws can cause
sensor damage. For vehicles w/o sensors install the supplied rubber plugs.
STEP 10 //
Remove the (2) 16mm bolts on each side
securing the bumper mount to the factory rear bumper.
Remove bumper mount.
STEP 9 //
Located behind the license plate, remove the (2)
16mm bolts securing the center of the bumper mount to the
bumper.
STEP 5 //
Using a flat head screw driver, push in the metal
tabs on the trailer plug connector and remove from the factory
bumper. Transfer to new bumper.
STEP 7 //
Optional Light:
If choosing the LED fog light
option, install the (2) LED Fog lights into the bumper using the
(2) M8x1.25x30mm bolts, flat washers, lock washers, and
nuts.
