2
Pre-drill oversized holes through lattice
(drill the largest
hole that screw head will allow without fi tting though
).
Center each screw in oversized holes and do not overtighten
to allow for expansion and contraction of lattice
Hang the lattice with a support every 24". Attach sides and
bottom loosely.
(Do not tighten all the way)
If using more than one panel, do not butt panels together.
Leave 1/4" gap to allow for expansion and contraction
Material Checklist:
Installing Without Mouldings:
Center each screw in
oversized holes.
Do not use
countersink screws.
Tape Measure
Saw
Rubber Mallet
Drill
Drill bits
Pencil
ATTENTION: Before you assemble the kit:
PLEASE TAKE A COMPLETE INVENTORY OF ALL PARTS USING THE CONTENTS.
DO NOT ATTEMPT TO ASSEMBLE THE LATTICE IF PARTS ARE MISSING OR DAMAGED.
Please do not return the product to the store, for assistance or replacement parts call:
1-800-336-2383
1
2
3
Thank you for choosing the Barrette Outdoor Living Lattice.
Please read the instructions completely before assembling
your Lattice. Retain manual and your dated sales slip for
future reference and warranty claims.
Before You Begin…
2 person installation recommended
It is the responsibility of the installer to meet and/or
exceed all code and safety requirements, and to obtain all
required building permits. The deck and railing installer
should determine and implement appropriate installation
techniques for each installation. Barrette Outdoor Living and
its distributors shall not be held liable for improper or unsafe
installations.
Before installing, check with your local building code offi cial
or structural engineer to determine the quantity and spacing
needed.
Lattice
Wood
1/
4" (
6,35 mm)
1/
4" (
6,35 mm)
