19
10.3 Inspection
Check each push handle for evidence of bending.
Check each push handle for evidence of cracking through nutsert holes.
Check handgrip is secure.
Check for free movement of plunger. Lubricate with light oil.
Check that plunger locates in the hole at rear of the side frame.
Ensure nyloc nut still grips thread.
10.4 Push Handle Removal
Unscrew 4 off M5x20 countersunk screws holding the seatback upholstery to the Push
Handle Assembly.
Unscrew 1/4” UNF nut and withdraw the bolt.
10.5 Push Handle Fitting
Insert 1/4 UNF bolt through Push Handle and hinge bush. Tighten the nyloc nut until Push
Handle pivots freely without excessive free-play.
Fit 4 off M5x20 countersunk screws to hold the seat back upholstery to the Push Handle
Assembly.
Wrap the 50mm wide Velcro strap around the lower end of the Push Handle and secure to
the rear.
