Barreto 1324TK, Руководство пользователя

Страница: 12 / 22

1324TK - 1624TK OWNER’S MANUAL 12/4/14 Page
12
of
22
CHAIN VALVE ADJUSTMENT
The chain valve control should be adjusted to completely activate the chain valve when the dig chain
control is in ‘ON’ position. To check this adjustment:
1.
Put the chain on/off control in ON position (with engine stopped).
2. Pull the clutch lever on left handlebar up until it touches the handgrip.
3. While holding clutch lever up, push on the chain forward/neutral/reverse lever. It should be at the
end of its stroke, thus not move down any more.
If the chain F/N/R lever can be pushed down more, the valve spool lever should be adjusted.
To make this adjustment:
1.
Remove back cover from the control panel.
2. Loosen the 2 bolts on valve lever and rotate the lever plate down about 1/16” (1.6mm).
3. Re-tighten the bolts and check the lever stroke.
Adjust so the valve lever comes to the end of its stroke just as the clutch lever touches the handgrip
when chain valve control is in ON position.