LM56/66/18G
5
LM56/66/18G
Installing the LM56/66/18G
Grooved Front Roller Kit
Section
Step
Illustration
Description
1
Screw nut, Part (4) onto threaded leg of bolt,
Part (3). When threading the nut, Part (4) onto
Part (3), be sure to put round side of Part (4) on
first. Repeat this so you have 2 sets of locking
bolts. Now slightly screw threaded leg of Part
(3) into front threaded hole on each roller
bracket, Parts (2) and (1). Screw each locking
bolt assembly by hand, so that the leg of Part
(3) does not protrude into round cutout of Parts
(2) and (1).
2
Hold front roller assembly, Part (5) with
exposed shaft end facing upward, slide one
washer, Part (6) onto protruding shaft of front
roller, Part (5). Then slide left roller bracket,
Part (2) onto shaft of Part (5).
3
Make sure that the machined flat portion of
shaft that faces to the locking bolt on the shaft
of Part (5) is facing forward, as in the direction
of the threaded hole on the front side of Part (2).
4
Now tighten down the locking bolt, Part (3) to
contact the flat portion of the shaft. Secure
locking bolt's position by tightening Part (4) to
front side of Part (2). Do not over torque. This is
currently a temporary step to hold the shaft into
the desired position.
