7
Installing the stand
1) Temporarily secure the left side of the stand to the frame with the bolt, washer
(inside), and nut (outside).
2) Put the spring on the projection of the frame and the projection at the right edge of the
stand.
3) While pulling the right side of the stand backward, make alignment with the hole in
the frame, and secure the stand with the bolt, washer (inside), and nut (outside).
4) Tighten the bolt, washer, and nut at the left side of the stand that were temporarily
secured.
1-2
Confirmation of the operation of clutch lever and brake lever
Check that the clutch and brake operate completely.
When adjustment is necessary, make adjustment according to "5-8. ［Important］
Adjustment of engine clutch section."
Connection of engine switch cord
When assembling the handle, check the connection of the engine switch cord. There are
two connections - plug and crimp terminal.
1) The plug is connected to the plug that is connected to the engine.
2) The crimp terminal is secured to the engine crankcase with a hexagon bolt. When the
connection of the engine switch cord is incomplete, the engine will not stop even if the
engine switch is operated. Check that the cord is correctly connected.
1-3
1-4
WARNING
Put the spring on the projection.
Temporarily secure the
left side of the stand.
Tighten the
left side of
the stand.
While pulling the right side
of the stand backward,
make alignment with the
hole and secure the stand.
Plug
Crimp terminal
