Baroness LM551, Руководство по эксплуатации для владельца, Страница: 63 / 102

Cutting Work
Cutting Work
Warning
Do not start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Caution
Be sure to operate at an appropriate speed for
the mowing site.
When cutting over bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Reel rotation will be turned on or off based on
the sensor-detected position of the mower
units.
Please note that if you stop operating the
mower unit up/down lever before the mower
units are raised completely, reel rotation may
not stop.
Caution
After sand topdressing, close the cutter cover.
Otherwise, sand may fly out and get in your
eyes.
Important
Mow with the lever shifted to the "Down"
position.
When the lever is returned to the neutral
position, the cylinders are fixed, preventing
mowing on undulations.
Release the mower lock levers (latches) for
mower units #4 and #5.
Start the engine.
"Procedure to Start Engine" (Page 4-21)
Raise all mower units.
Firmly depress the brake pedal to release
the locking pedal for releasing the locked
brake pedal. 1.
2.
3.
4.
Shift the throttle lever to rev the engine up to
the maximum rpm.
Set the traveling/working selector switch to
the "Working" position.
Shift the mower unit up/down lever to the
"Down" position to lower the mower units.
Set the reel rotation switch to the "Rotation"
position to rotate the reel cutters (cutting
cylinders) of all mower units.
Depress the traveling pedal to start cutting
work.
Note:
During the work, the reel cutters (cutting
cylinders) will rotate or stop in sync with the up
and down motion of the mower units.
Removal/Installation of Grass Catcher
Caution
Stop the engine before removing or installing
the grass catcher.
Set the reel rotation switch to the "Stop"
position.
Lower the mower units.
Apply the parking brake.
Stop the engine.
Remove or install the grass catcher.
Removal of grass catcher:
Lift up the grass catcher, and remove the
mounting pins on the left and right sides of the
grass catcher from the grass catcher mounting
brackets.
Installation of grass catcher:
Install the mounting pins on the left and right
sides of the grass catcher into the grass
catcher mounting brackets.
1
2
2
3
3
bos35l-003
Removal/Installation of Grass Catcher_001
5.
6.
7.
8.
9.
1.
2.
3.
4.
5.
Handling Instructions
LM551
Handling Instructions
Page 4-39
Cutting Work