BARONESS LM180 TRIPLE MOWER – BLADE/CUT ADJUSTMENT
Before commencing any blade adjustments it is important that the cutting units are
thoroughly cleaned and dry.
To check that the blades are cutting
correctly, use a strip of paper as shown.
With the strip of paper held square to the
bottom blade, rotate the cutting cylinder
and see if the blades cut the paper.
Never
rotate the cutting cylinders using your
hands as the blades are very sharp and
can cause serious injury. Use a short
length of wooden pole to rotate the
cylinder.
If the paper is not cut then you will
need to lower the cutting cylinder
down onto the bottom blade.
To do this, first of all loosen the top
locking nut on the cylinder adjustment
mechanism. Repeat this for both sides
of the cutting unit.
Once the top locking nut is loosened you need to
lower the cylinder down slightly onto the bottom
blade.
To do this firstly lower the bottom adjusting nut
by turning it clockwise a couple of flats.
Then repeat his exercise with the top nut, turning
it clockwise a couple of flats.
This will have the effect of lowering the cutting
cylinder.
Repeat this procedure for both ends of the cutting
unit.