8
www.barosnt.com
Area Mapping
1.
Open
Windows Control Panel
and click , typically found in the “Programs” category.
A “Tablet” folder is also created in the “Programs” list of the Start Menu during installation, so you
may also find it there.
2. Enter Mapping and set the
Select the Monitor
as
where the touch sensor will be active. In
our installation, only the tablet monitor was connected, so “Full Monitor” was selected.
.
3. If you find the pen touch is
inaccurate and calibration is required
upon installation of the monitor, click
Calibrate for manual adjustment.
During calibration, touch the pen tip
to the center of the red targets that
appear on the screen. After touching,
the next target will appear. 4 appear
in total, 1 in each corner. It is
recommended to use this calibration
method over the built in Windows
calibration.
