Barnes 4030HCU, Инструкция по установке и эксплуатации

Страница: 4 / 12

4
SUCTION/DISCHARGE . 4” (102mm) Suction, 3” (76mm)
Discharge, 125 lb Flange.
Discharge can be placed in 8
defferent locations depending on
piping requirements
LIQUID TEMPERATURE 180°F (82°C) Continuous
BODY ............................. Cast Iron ASTM Class 30, with Air
vent, Vacuum pressure and drain
plugs.
PEDESTAL ..................... Cast Iron ASTM A Class 30
IMPELLER
Design ........... Enclosed type
Material ........ Cast Iron ASTM Class 30
Dynamically Balanced, ISO G6.3
WEAR RING ................... Bronze
SHAFT ............................ Steel
SHAFT SLEEVE ............ Bronze
HARDWARE .................. 300 Series Stainless Steel
PAINT ............................. Air dry enamel
SEAL: Design .......... Single Mechanical
Lubrication.... Self-Lubrication
Material ........ Rotating Faces - Carbon
Stationary Faces - Ni-Resist
Elastomer - Buna-N
Hardware - 300 series stainless steel
BEARING-PUMP END:
Design .......... Single Row, Ball
Lubrication.... Grease, Factory Lubrication
Load ............. Radial & Thrust
BEARING-DRIVE END:
Design .......... Single Row, Ball
Lubrication.... Grease, Factory Lubrication
Load ............. Radial & Thrust
OPTIONAL EQUIPMENT: Discharge Check Valve, Hand
Primer, Base & OSHA Coupling Guard, Flex Coupling,
Strainer, Bronze Impeller, Companion Flange, Flange Gasket.
SECTION: A - PUMP SPECIFICATIONS:
inches
(mm)
IMPORTANT!
1.) DO NOT USE FOR PUMPING FLUIDS WITH A FLASH POINT OF LESS THAN 100°F.
2.) MAKE CERTAIN THAT PUMP AND/OR MOTOR ASSEMBLY AND CONTROLS HAVE THE APPROPRIATE RATINGS FOR THE GIVEN
APPLICATION AREA CLASSIFICATION (ie DIVISION I, AGENCY LISTING ETC.)