Barko 6025, Руководство по обслуживанию

Страница: 40 / 58

page 40 page 40
page 40 page 40 page 40
240 Harvester Feller/
Buncher
The following tables contain information about the different possible failures that could occur for each module
subsystem. In most cases when an error is detected, a message will be presented on the master display together with
an error code on the module. In some cases, the module will turn off or at least shut down the outputs, to increase
safety.
IQAN XS2 IQAN XS2
IQAN XS2 IQAN XS2
IQAN XS2
FAILURE MODE FAILURE MODE
FAILURE MODE FAILURE MODE FAILURE MODE
1 +VREF Open VIN out of range, will create a VIN error =>
VIN=Predefined error value. (a)
2 -VREF Open VIN out of range, will create a VIN error =>
VIN=Predefined error value. (a)
3 +VREF Short-circuit to -VREF VREF error => VIN out of range, will create a VIN
error => VIN=Predefined error value. (a)
4 +VREF Short-circuited to +BAT VREF error => VIN out of range, will create a VIN
error => VIN=Predefined error value. (a)
5 +VREF Short-circuited to -BAT VREF error => VIN out of range, will create a VIN
error => VIN=Predefined error value. (a)
6 -VREF Short-circuited to +BAT External fuse (if <7.5A) on +BAT blows.
7 -VREF Short-circuited to -BAT Not detected.
1 CAN-H to -BAT No CAN communication. All output turned off.
2 CAN-L to -BAT No CAN communication. All output turned off.
3 CAN-H to +BAT No CAN communication. All output turned off.
4 CAN-L to +BAT No CAN communication. All output turned off.
5 CAN-L open circuit No CAN communication. All output turned off.
6 CAN-H open circuit No CAN communication. All output turned off.
7 CAN-L to CAN-H No CAN communication. All output turned off.
8 CAN-termination failure, termination on No effect
9 CAN-termination failure, termination off Dependent on CAN size and number of CAN nodes.
(a) Measure is controlled by CAN master and application as a result from the CAN error message. (a) Measure is controlled by CAN master and application as a result from the CAN error message. (a) Measure is controlled by CAN master and application as a result from the CAN error message. (a) Measure is controlled by CAN master and application as a result from the CAN error message. (a) Measure is controlled by CAN master and application as a result from the CAN error message.
Turning outputs Turning outputs Turning outputs Turning outputs Turning outputs off is controlled by CAN master unit and therefore delayed off is controlled by CAN master unit and therefore delayed off is controlled by CAN master unit and therefore delayed off is controlled by CAN master unit and therefore delayed off is controlled by CAN master unit and therefore delayed
maximum 2 bus cycles. maximum 2 bus cycles. maximum 2 bus cycles. maximum 2 bus cycles. maximum 2 bus cycles.
Failure mode Failure mode Failure mode Failure mode Failure mode Effect Effect Effect Effect Effect
Failure modes for VREF Failure modes for VREF
Failure modes for VREF Failure modes for VREF
Failure modes for VREF
Failure mode Failure mode
Failure mode Failure mode
Failure mode Effect Effect
Effect Effect
Effect
Failure modes for CAN interface Failure modes for CAN interface
Failure modes for CAN interface Failure modes for CAN interface Failure modes for CAN interface