Refresh Interval
Defines the refresh interval for the control page in seconds. If Refresh Control Page is set to
"Manual", then this configuration option is not visible.
Default:
"5 seconds"
When you finish modifying your settings, click on the “Submit” button to store the changes, or
“Cancel” to ignore all modifications.
Volume Units
Allows to switch between using % and dB for the volume. Please take care to update all
your playlists accordingly to have the correct volume units in the #BARIX-4 config line.
Default: "%"
Debug Mode
Enables more verbose syslog messages output.
Default:
"No"
Enable IR Control
Enables the IR control support. When set to
"Yes"
, then the IR Source configuration
option also becomes visible.
Default:
"No"
IR Source
Allows to switch between using the Barix serial port IR dongle, or the build-in IR for
devices that have one (for example Extreamer 110/120/200).
Default:
"serial dongle"
4.2
Control Page
This is the default page when you open the device IP with your browser. To navigate to the
Control Page you can also click on the “Control” button from the navigation bar. If the “Refresh
Control Page” is set to Automatic, then the control page is refreshed regularly providing you
with up-to-date information about the device status.
There you can do one of the following:
●
Force refresh the page by clicking on the “Refresh” button on the top of the page
●
Change the current volume by clicking on the volume slider, or by dragging the slider
pointer. The volume can be updated also in 10% or 6dB steps by clicking on the
arrows. You should see the new updated value printed on the web page;
●
Navigate through the songs in the current playlist by clicking on the play, pause, stop,
play next and play previous buttons from the button bar. You should see the updated
17
Web Interface