4
• 1. INSTALLATION OF THE EXHAUST PIPE JOINT
fig.1
• Adjust angle of the exhaust to desired position.
• 2.
DRYER MUST BE INSTALLED HORIZONTALLY
• Clothes dryer is not allowed to stand upside down. When the clothes dryer is placed on
the horizontal ground or a countertop desktop, make sure that the floor and desktop are
firm and not tilted, so that the clothes dryer is horizontal.
•
3. WALL MOUNTED INSTALLATION refer to fig’s 2 & 3
• 3.1 Installation of clothes dryer bracket
•
When the clothes dryer is installed on the bracket is necessary to ensure that the wall bracket is firmly fixed to a surface capable of withstanding
the weight of the dryer and its load.
•
There should be at least a 13 cm distance between the bracket and the wall.
•
3.2 Wall installation of the dryer
• Determine the wall position of the dryer and note that the distance between the top of the dryer and the ceiling is recommended to be greater
than 100 mm.
•
a. Fasten the wall bracket fig. 2.2 to the wall with an expansion screw (M6).
•
b. Fix the wall hanging bracket fig.2.1 to the rear of the dryer with four 4 x 10 large flat head tapping screws (provided).
•
c. Screw the wall hanging braces fig.2.3 to the bottom of the rear of the body of the dryer.
• d. Hang the clothes dryer safely on the hook.
DAILY MAINTENANCE fig.4
• WARNING!
Remove from mains supply before performing maintenance.
•
To ensure safe operation of the dryer air outlet and air inlet filters should
be cleaned regularly.
• 1. OUTLET FILTER CLEANING
•
Outlet filter needs to be cleaned after each use.
•
a. Remove the filter from inside the drum:
•
Insert your hand into the drum and gently pull the filter out using the
four cutouts in the air mask.
•
b. Carefully ease the filters apart noting their orientation.
• Use a soft brush or vacuum cleaner to clean each of them.
•
Take care to not damage the filters.
c. Install the filters in the correct order and orientation:
cotton first, then net, finally the air mask and refit them into the drum.
•
Check that the filters are securely fixed.
•
2. INLET FILTER CLEANING
•
a. Release the inlet filter door by tilting it upwards and remove it.
• b. Use a soft brush or vacuum to remove the dust attached to it.
• NOTE:
Clean filter once a month.
• c. Replace after cleaning.
• 3. DRYER CLEANLINESS
• Wipe the dirt inside the drum or on the outside of the dryer with
a damp cloth.
fig.1
fig.2
fig.3
fig.4