46
·
Repare all forms of safety prevention for the type of operation being performed.
·
The maximum pressure of the compressed air used for blowing and cleaning
operations must be 2 bar
·
Carry out maintenance operations at least four hours after the arrest of the driver
of the tractor, in order to avoid contact with hot parts of the machine.
·
If you use compressed air to clean the machine you need to protect yourself with
appropriate glasses.
·
When maintenance involves access to machine parts which cannot be reached
according to the ground, and in any case points higher than 1.50 m from the
ground, use a ladder or a platform compliant with current regulations.
·
Do not perform repairs that unknown. Always follow the instructions and in the
absence of these contact your supplier or experienced personnel.
·
Note: Replace hydraulic hoses whenever damage and not later than 1 year.
·
Before performing maintenance operations and repairs under elevated parts of
the machine make sure that the locking devices are correctly positioned;
·
Avoid prolonged and repeated skin contact with lubricating fluid fuels, as they
may create skin disorders or other syndromes;
do not ingest lubricating fluid fuels. In case of accidental contact with eyes rinse
well with water the part affected by contact;
·
During all cleaning or replacing the filters make sure there is adequate ventilation
to prevent the accumulation of toxic fumes;
·
Do not perform welding in closed or poorly ventilated areas;
·
Do not perform welding on varnished surfaces or close to avoid the development
of toxic vapors. Remove the paint with suitable products, then wash the surfaces
and allow to dry.
·
Do not make welds without having previously emptied and cleaned the spraying
circuit;
·
When using compressed air for cleaning the filters carry safety glasses with side
shields and a mask in order to avoid the risk of personal injury due to dust
particles. It is suggested to clean the equipment in ventilated areas;
·
Pay special attention before removing the caps or lids of tanks, radiators or
cylinders: rotate them carefully to download any remaining pressure;
·
During bleeding, defiladed position stand and always use protective eyewear.
·
Loosen the bleed screw a few turns slowly to allow the condensation or fluid to
escape..
·
Release pressure from the channels before making speeches;
·
Do not use hands to locate leaks of fluids under pressure;
·
Fluid leaks under pressure can penetrate the skin and eyes with very serious
consequences;
·
Carefully wash the machine after use, making it work with clean water;
·
Absolutely avoid to enter the tank to perform any cleaning or maintenance work;
·
Check daily the condition of pipes and fittings, if they show signs of ageing (cracks,
cuts) or mechanical damage (deformation, crushing) replace them immediately;
·
Before beginning the repair work of the tank must be cleaned and emptied the
spraying circuit;
·
Keep the nozzles in good condition, regularly checking that there are no cracks, worn
parts or fillings..
