barfield 2312G-15, Руководство пользователя

Страница: 20 / 28

2312G INSTRUCTION MANUAL
56-101-00550-D CH. 3
11/7/14 Page 12 / 20
(b)
Disconnect the 45V battery leads from the 45V battery
.
(c)
Connect a new 9 Volt alkaline battery to the 9V Input terminals of the Voltage Converter
observing polarity.
WARNING: POWERING THE 137-08002 FROM ANY SOURCE OTHER THAN AN
ALKALINE 9 VOLT BATTERY MAY CAUSE DAMAGE TO THE CONVERTER.
NOTE:
The converter output can be checked by connecting a DVM (set for 200 VDC) in parallel
with 30K
Ω of resistance (to the 45V Output terminals observing polarity. The output
voltage with a fresh battery should measure approximately 47 VDC.
(d)
Connect the 45V battery leads to the 45V Output terminals of the Converter observing
polarity as depicted in Figure 1.
Figure 5 BATTERY AND CONVERTER
(e)
Carefully install the coupled 9V battery and Converter pair into the 2312G 45V battery
clips and terminals.
(f) Re-install the 2312G panel assembly into the case and replace the 4 panel screws.
(3) Operation:
(a)
To check the 2312G 45V Insulation battery once installed, set the 2312G FUNCTION
switch to INS position then depress and hold the CAL pushbutton while varying the CAL
ADJUST to set meter pointer over the Insulation 0 ohm mark.
NOTE:
The 137-08002 converter is essentially asleep until either the 45V level is checked or an
Insulation measurement is performed and so does not drain the 9V battery.
(b)
Perform Insulation testing with the 2312G in the normal fashion as detailed in the 2312G
Instruction Manual P/N 56-101-00550
.
(4) Battery Check:
Perform the 2312G battery check before each test procedure that follows.
(a) To check the 45-volt battery used for insulation testing:
1) Rotate the “FUNCTION” selector switch to “INS” position.