Bard EIFM-5, Руководство по установке

Страница: 5 / 13

Manual 2100-220
Page 3
bracket. Once the economizer is fully inserted,
slide the economizer to the right until it is tight
against the back of the control panel. (See Figure
2.)
IMPORTANT: Position front lip of economizer
on top of front grille and condenser partition (See
Figure 2 inset.) This is important to ensure
proper drainage of any water entering damper
assembly.
LEFT HAND UNITS – Slide the economizer to
the left until it is tight against the back of the
corner panel.
6. Mount mixed air thermistor to blower partition
with screws provided. Bracket with sensor
installs on top of blower partition and screws are
installed from the underside. Route wires as
shown and secure with wire tie. Connect wires to
thermistor. (See Figure 2.)
7. Open unit control panel to gain access to unit low
voltage terminal block.
8.
FOR LEFT HAND UNITS
– Reroute
economizer wiring harness to the left side of the
economizer.
(See Figure 2A.)
9. Route electrical harness leads through the 7/8”
bushing in control panel (Figure 2) into low
voltage box.
FIGURE 2
MIS-423
SIDE SECTION
RIGHT SIDE OF ECONOMIZER
SERVICE DOOR
LIP OF ECONOMIZER IS TO BE
BETWEEN THE CONDENSER
GRILLE AND SERVICE DOOR
FRONT GRILLE
CONDENSER PARTITION
THERMISTOR WIRES
TOP VIEW OF
BLOWER PARTITION
THERMISTOR
PART #8602-043
THERMISTOR BRACKET
PART #113-264
INSTALL THERMISTOR TO
BLOWER PARTITION. ROUTE
WIRES FROM ECONOMIZER
BEHIND FILTER BRACKET FILL
& THROUGH WIRE TIE.
WIRE TIE TO SUCTION LINE
LOW VOLTAGE WIRES TO
TERMINAL STRIP
WHEN INSTALLING ECONOMIZER, POSITION SO THAT HOLE
IN FRONT LIP IS CENTERED OVER HOLE IN CONDENSER
GRILLE TO INSERT A SELF DRILLING SCREW
MIST ELIMINATOR