2100-566D
Page
6
of
20
9.
Enter
button to save choice
10.
Left
button (3x) to home screen.
System Enable
– to enable heating / cooling from home screen, press:
1.
Right button
to access the
Main Menu Screen
2.
Down
button through entries to highlight
System
3.
Enter
button to select System and enter
System Screen
4.
Enter
button again to highlight current
System Enable
choice
5.
Up/Down
buttons to choose from available System Enable options
Auto
: System is in “Auto-Changeover” mode. HVAC system will cycle heating and cooling automatically to
stay within preset heating and cooling setpoints.
Heating
: System is in “Heating-Only” mode. HVAC system will cycle heating in reference to Heating
Setpoint only. Unit will not activate cooling sequence.
Cooling
: System is in “Cooling-Only” mode. HVAC system will cycle cooling in reference to Cooling Setpoint
only. Unit will not activate heating sequence.
Emer HT
: HP mode only.
Off
: HVAC system is inactive.
6.
Enter
button to select/save appropriate mode selection
7.
Left
button (2x) to navigate back to home page.
Temperature Setpoints
– to access temperature setpoints from the home screen, press:
1.
Right
button to access the
Main Menu Screen
2.
Down
button through entries to highlight
Setpoints
3.
Enter
button to select
Setpoints
and enter
Setpoints Screen
4.
Enter
button to select
Cool Setpt
3
5.
Up/Down
buttons to enter appropriate cooling setpoint
6.
Enter
button to save new
Cool Setpt
4
7.
Down
button to highlight
Heat Setpt
8.
Enter
button to select
Heat Setpt
9.
Up/Down
buttons to enter appropriate heating setpoint
10.
Enter
button to save new
Heat Setpt
11.
*REPEAT STEPS IN LIKE FASHION FOR COOL SETBACK & HEAT SETBACK TEMPERATURES, DEHUM SETPOINT & SPAN,
& FOR C0
2
SETPOINT IN PARTS PER MILLION & C0
2
SPAN OF CONTROL IN PARTS PER MILLION (IF AVAILABLE).*
12.
Left
button (2x) to navigate back to home page
NOTE
3
: The controller will not allow heating/cooling setpoints to contradict one another, or to be within a degree of
conflicting operation.
NOTE
4
:
Any system start-up with indoor ambient temperatures lower than 56° F., or above 86° F. will experience an
internal Low-Temperature or High-Temperature alarm. This will not affect normal operation, and can be cleared easily.
Terminal Descriptors
–
Optional Inputs
NOTE: Use twisted shielded pair for optional outdoor and indoor air sensors. Connect shield (drain) to 24V common.
D SC
A
W2 W1/E SC Y2
Y1 YO
O/B G
IN9 ROS GND REM
OAT LAT
SC
A+ B-
GND L COM 24V
CompleteStat
TM
8301-014 Leaving Air
Temperature Sensor
8301-061 Outdoor Air
Temperature Sensor
8301-062 Indoor Remote
Air Temperature Sensor
Remote Occupancy Sensor
(TBD)
BACnet Commercial
Controls Platform
