Barco XLM H25, Руководство пользователя

Страница: 23 / 111

2. Installation Guidelines
2.10 Charging the batteries of the rugged remote control
2.10.1 Preparing the charger
What can be done ?
The charger can be fitted with one of the four supplied power plugs.
Image 2-15
Possible power plugs
1 For Australia
2 For US/Japan
3 Europe
4 UK
How to mount the correct plug ?
1. Pull the plug to be changed upwards until it is completely removed from the charger. (image 2-16)
2. Place the plug to be mounted on the charger and guide it downwards by using the guiding slots. (image 2-17)
3. Push the plug downwards until it clicks and is locked into the charger. (image 2-18)
4. Check if the plug is well locked.
It must not stick out of the charger.
Image 2-16
Remove plug
Image 2-17
Guiding grooves
Image 2-18
Mounting the plug
2.10.2 Charging the batteries
When charging the batteries
Charging is required whenever the batteries are low. The status of the batteries can be seen on the main menu (third line) or in the
diagnosis menu.
BAT=ACT The remote is working on batteries, there is no supply via external power source.
BAT=LOW The batteries are running low
Possible ways to charge the batteries
The batteries can be charged in one of the following ways :
•
Via the battery charger
• Via the XLR connection with the projector when the projector is in standby or in operational mode.
How to charge via the adapter ?
1. Plug the female power connector of the charger into the male connector at the right side of the remote control.
R5976690 XLM H25 03/09/2004 19