3-1
Hardware Set Up
5975428 BARCOVISION 3200 290997
3
Set up of the baud rate for communication with a computer.
S1
S2
2
1
3
On
Off
HARDWARE SET UP
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. With DIP switches S2(1,2,3) on the
controller unit, it is possible to select the baud rate (communication
speed).
Gaining access to the DIP switches
Power down the projector and unplug the power cord from the wall
outlet.
Turn both lock screws with a screwdriver or coin counter
clockwise.
Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly.
The processor module with the DIP switches is located on the front
side.
Loosen the locking
screws.
Open the top cover
Baud rate setting
Change the position of the DIP switches with a small
screwdriver.
If all switches are in the correct position, close the top
cover and secure it by turning the lock screw clockwise.
Connect the power cord to the wall outlet and switch
on the projector.
baud rate
S2/1 S2/2
S2/3
9600
OFF
OFF
OFF
4800
ON
OFF
OFF
2400
OFF
ON
OFF
1200
ON
ON
OFF
600
OFF
OFF
ON
300
ON
OFF
ON
150
OFF
ON
ON
75
ON
ON
ON
BAUD RATE SWITCHES
