Barco ULC-30A, Руководство по обслуживанию

Страница: 43 / 102

8. Primary pump unit
1
1
1
1
Image 8-3
Removing the connection box cover
4. Disconnect the four electrical wires (reference 1, 2, 3 & 4 image 8-4). Use the nut spanner 7 mm.
Tip: While the cable numbers are printed on the black wires, it is still advised to mark these wires with cable markers or similar
tool if your chiller is located in a dimly lit area. This will make it easier to reconnect the wiring afterwards.
4
3
1
2
Image 8-4
Removing the pump motor wiring
5. Loosen the cable gland and remove the cable from the connection box.
Note: Do not damage the wire connectors when pulling out the cable.
6. Install the pump motor connection box cover. Use the Phillips screwdriver PH2 to install the 4 screws (reference 1 image 8-5).
1
1
1
1
Image 8-5
Installing the connection box cover
R5906015 ULC-30A 01/02/2018 39