Barco UDX 4K22, Руководство по установке

Страница: 39 / 120

R5906113 UDX 07/07/2017 35
3. Physical Installation
3.5 Connecting the projector with the power net
C
AUTION
:
Use only the power cord provided with the projector.
How to connect with local power net
1. Ensure that the power switch stands in the ’0’ (OFF) position (reference 1 image 3-7).
2
3 1
Image 3-7
Power input
2. Connect the female side of the power cord with the power input socket of the projector (reference 2).
3. Secure the power plug by locking the plug holder clamp (reference 3).
4. Connect the male side of the power cord to the local power net.
Caution: Ensure that the power net meets the power requirements of the projector.
W
ARNING
:
Do not attempt operation if the AC supply and cord are not within the specified voltage and power
range.
C
AUTION
:
Once the projector is switched to standby, the cooling fans will continue to run for approximately
30 seconds to ensure that the projector and light source have sufficiently cooled, at which point the fans will
automatically decrease to standby. To avoid thermal stress that can lead to premature light source failure,
never unplug the power cord while the cooling fans are running. Never unplug the power cord to power down
the projector, first switch off the power switch and then unplug the power cord.
Fuses
The projector is protected with an automatic circuit breaker of 25 A which is built into the power switch.
The voltage meter is protected with a fuse (1A) which is located on the neutral bonding cable. If necessary to replace this fuse,
consult a service technician.