Barco SP4K-B, Руководство по безопасности

Страница: 8 / 14

R5912127 /03 SP4K-B 8
Electric related safety labels
Label image Label description
Label location
Disconnect the power to the unit mains terminals and unplug
power cord at UPS inlet before removing this cover. See ID-
label for ratings.
WARNING : HIGH LEAKAGE CURRENT
EARTH CONNECTION ESSENTIAL BEFORE
CONNECTING SUPPLY.
SEE INSTALLATION
INSTRUCTIONS BEFORE CONNECTING TO THE
SUPPLY
.
Déconnecter l ’ alimentation des bornes du réseau et
déconnecter le câble de la prise UPS avant de retirer ce
couvercle. Voir l
’ étiquette d ’ identification pour les
paramètres. ATTENTION : COURANT DE FUITE ÉLEVÉ
RACCORDEMENT À LA TERRE INDISPENSABLE AVANT
LE RACCORDEMENT AU RÉSEAU
VOIR LA NOTICE
D ’ INSTALLATION AVANT DE RACCORDER AU RÉSEAU
在取下此外殼前，斷開投影機主電源端的電源並從 UPS 電源
插座上拔下電源線。 額定功率參閱產品標籤。 警告：大漏電
流，在接通電源之前必須先接地。 在連接電源前請查看安裝
說明書
在取下此外壳前，断开投影机主电源端的电源并从 UPS 电源
插座上拔下电源线。 额定功率参阅产品标签。 警告：大漏电
流，在接通电源之前必须先接地。 在连接电源前请查看安装
说明书。
Screened on Mains cover
CAUTION! DOUBLE POLE / NEUTRAL FUSING HIGH RESIDUAL VOLTAGE - WARNING :
RISK OF ELECTRIC SHOCK SWITCH OFF AND UNPLUG BEFORE REMOVING THIS
COVER. SEE INSTRUCTIONS BEFORE REMOVING SMPS.
注意 兩極 / 中性熔斷 高殘餘電壓 . 警告：存在觸電風險 移除此蓋板之前， 請先關機並拔掉電源插
頭 移除 SMPS 之前，請先閱讀說明 .
ATTENTION DOUBLE PÔLE / FUSIBLE SUR LE NEUTRE HAUTE TENSION RÉSIDUELLE -
ATTENTION : RISQUE DE CHOCS ÉLECTRIQUES . ÉTEINDRE ET DÉCONNECTER AVANT
OUVERTURE DU COUVERCLE. LIRE LES INSTRUCTIONS AVANT DE RETIRER LE SMPS.
Printed on SMPS cover
Only for SP4K-55B Caution: Cable hot plugging is forbidden.
1.4 High Brightness precautions: Hazard Distance
HD
Hazard Distance (HD) is the distance measured from the projection lens at which the intensity or the energy per surface unit
becomes lower than the applicable exposure limit on the cornea or on the skin. The light beam is considered (to be) unsafe
for exposure if the distance from a person to the light source is less than the HD.
Restriction Zone (RZ) based on the HD
The HD depends on the amount of lumens produced by the projector and the type of lens installed. See chapter “ HD in function of
modifying optics ” , page 11 .
To protect untrained end users (as cinema visitors, spectators) the installation shall comply with the following installation requirements:
Operators shall control access to the beam within the hazard distance or install the product at the height that will prevent spectators' eyes
from being in the hazard distance. Radiation levels in excess of the limits will not be permitted at any point less than 2.0 meter (SH) above
any surface upon which persons other than operators, performers, or employees are permitted to stand or less than 1.0 meter (SW)
lateral separation from any place where such persons are permitted to be. In environments where unrestrained behavior is reasonably
foreseeable, the minimum separation height should be greater than or equal to 3.0 meter to prevent potential exposure, for example by an
individual sitting on another individual's shoulders, within the HD.
These values are minimum values and are based on the guidance provided in IEC 62471-5:2015 section 6.6.3.5.
Safety