Barco SLM R12 Plus, Руководство по обслуживанию

Страница: 188 / 281

27. Maintenance
A
C
B
Image 27-8
Removal motor Left/Right shift
2. Remove the 2 screws (B) fastening the copper motor support (C) onto the lens block (D).
3. Remove the motor for replacement.
Caution: When fixating the copper motor support onto a new motor, be careful not to turn the 2 fixation screws deeper than
the thickness of the motor reduction unit (Illustration: see Motor unit Up/Down).
27.2 Cleaning/Replacement of the Dust Filters
C
AUTION
:
Always turn off the projector before proceeding to dust filter cleaning or replacement.
To avoid contaminating the projector with its removed dust filters, clean the dust filters far away from the
projector or by preference clean the filters in another room.
Cleaning frequency
The cleaning frequency of the dust filters depends on the environment conditions. In any case, the dust filters must be cleaned
whenever you replace the lamp. In case the projector operates in a dusty or dirty environment, step up the cleaning frequency of all
dust filters, e.g. every 2 months. A clogged filter reduces air flow, and can lead to overheating and failure of the projector.
To guarantee maximum operating performances of the projector,
ALWAYS
replace damaged filters and too contaminated filters.
Overview
• Location of the Dust Filters
• Cleaning/Replacement of the Dust Filters
186 R5976820 SLM R12+ PERFORMER 08/03/2005