![background image](http://html1.mh-extra.com/html/barco/rml-w6/rml-w6_user-manual_4464228039.webp)
39
•
H Start
Use
to adjust the projected image's horizontal position.
If the projected image is not at the center of the screen (i.e. shifted to right or left) and
ends up being cropped, use this function to adjust the image's horizontal position.The
following image is an example of test image from an external signal source:
Native picture
Skewed left
Skewed right
•
H Phase
Use
to adjust the projected image's phase.
Use this function to adjust the phase of pixel sampling clock (relative to input signal).
Should the image still flicker or show noise (i.e. edges on texts) after optimization, adjust
phase accordingly.
•
V Start
Use
to adjust the projected image's vertical position.
If the projected image is not at the center of the screen (i.e. shifted up or down) and ends
up being cropped, use this function to adjust the image's vertical position.The following
image is an example of test image from an external signal source:
原始圖面
圖面下偏
圖面上偏
Native picture
Skewed down
Skewed Up
It is recommended that when adjusting the image, the horizontal total should be adjusted before the
horizontal phase. However, if the image still flickers even after you have adjusted both, try lowering the
image noise.
Auto Image
When Auto Image was selected in the OSD menu, press
ENTER
to execute the automatic
image adjustment function.
By executing this function, the projector will resync the image. Use this function when the
image source is unstable or when you notice deterioration in image quality and the projector
will automatically adjust the image size, phase and timing. (The adjustment also applies to
PIP input source).
This function is identical to the
button on the remote control. You can simply use the hot
key on the remote control to execute this function.
6
OSD Menu description