Barco RETROGRAPHICS 808s, Руководство по установке

Страница: 22 / 33

Source Connections
6-3 5976002 RETROGRAPHICS 808s 100299
Connecting a RGB Analog source to port 3.
Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Barco interfaces which can be applied :
Universal analog interface R9826100
RGB 120 MHz analog interface R9826570
VGA interface 120V R9828079
230V R9828070
MAC interface 120V R9828059
230V R9828050
MAGIK interface 120V R9828129 & R9828128
230V R9828120 & R9828121
RGB analog input with automatic sync detection. (Separate H and V
sync inputs, with composite sync input or with sync signals on green)
Pin configuration D9 connector of the Analog input.
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
with the RCU or build in RCU, press digit button 3.
Connecting a RGB Analog source to port 4/5.
56,1 562875 5(027( / 5
5 /
PORT 4/5 PORT 3 COMM. PORT
PORT 1
PROJECTOR MODE POWER / MAINS
i nver. 75 ohm term.
Locations of the Termination Resistors and Switches
When changing a switch position or removing a resistor, turn off the
projector and unplug the power cord from the wall outlet.
75 W Termination resistors
In case of chaining (loop-through) the projectors, the 75
Ω
line
termination resistors must be removed from the RGB Input Auto Sync
Tracking Module when the projector is the last unit in the chain.
In case of a stand-alone projector, do not remove the resistors.
75
Ω
resistors on the module : line terminated.
75
Ω
resistors removed : line not terminated.
S1 Force Negative Sync
(ON=yes)
R81
Hsync
R101
Vsync
R41
(Blue)
R21
(Green)
R1
(Red)
S2 Blue in Green (ON=yes)
Line termination 75
Ω
resistors
RGB Input Auto Sync Tracking Module
Procedure to remove the line termination resistors :
➊
Turn off the projector and unplug the projector power cord.
➋
Put the projector in service position 2 (see p.5-2).
➌
Take out the RGB Input Auto Sync Tracking Module from the main
frame.
➍
Unsolder and remove the resistors.
To take out the RGB Input Auto Sync Tracking Module :
➊
press the module lock and lift up the module handle;
Top view
Top view
Side view
Side view
➋
repeat this action on both sides of the module and extract the
module out of the main frame.
Order number D9-
BNC cable : R9827840