3. Replacing a bad LED from an ILite LED board
3.5
Removing the LED driver
C
AUTION
:
Electrostatic Sensitive Device (ESD). To avoid equipment damage from electrostatic discharge,
use static control precautions in servicing this equipment. Field service or maintenance personnel should
be properly grounded before servicing. Wear an ESD wristlet when servicing this equipment. The use of
antistatic gloves is recommended.
Before you can remove the LED driver from the module base plate, you have to remove the controller unit
from the ILite tile first.
Necessary tools
•
Torx T20.
•
7 mm nut driver.
How to remove the LED driver from the module base plate ?
1. Release the four screws (P) of the LED driver (G) you want to remove from the module base plate (F).
P
G
F
Image 3-4
2. Remove the LED driver (G) from the module base plate (F).
Caution:
Be careful with the board to board connectors between the LED driver and the LED modules underneath.
Tip:
Mark the original position of the LED driver in the module base plate with a unique sign and place the same sign upon
the LED driver. This will prevent an accidental swap of LED drivers in case you removed more than one LED driver from
the module base plate.
16
R5976460 ILITE LED REPLACEMENT KIT 29/03/2007
Содержание R9851620
