Barco R9841020 Cine VERSUM Master, Руководство по установке

Страница: 145 / 161

20. Cine VERSUM Master Settings & Info
How to change the password
1. Select item
MODIFY PASSWORD
by rotating the jog dial on the Master or the ↑ or ↓ keys on the Remote Control.
2. Press the jog dial on the Master or the key ENTER on the Remote Control to confirm.
The sub menu NEW PASSWORD appears on-screen and in the graphical display, including the possibility to enter 4 digits,
composing the new password. (menu 20-4)
3. Start with filling in the new name, (Always 4 characters) as follows:
- Pressing the cursor keys ← or → on the Remote Control or pressing the jog dial on the Master allows to select the character
position (moving to the right).
- Pressing the cursor keys ↑ or ↓ on the Remote Control or rotating the jog dial on the Master allows to change the character (
Numeric characters can be entered remotely with the numeric keys on the Remote Control).
4. When the last character of the new password has been entered, the system returns to preceding menu.
5. Press EXIT on the Remote Control or select BACK in the graphical display menu, rotating the jog dial to select and pressing to
confirm, to leave the menu mode.
New Password
Enter new value
- - - -
Menu 20-4
20.4 Cine VERSUM Master Address
Overview
• About the Cine VERSUM Master Address
• Cine VERSUM Master Address change
• Selecting the Transmission Speed
• Selecting the Interface standard (RS232/RS422)
• RS422 data bus termination
• Diagnosis
20.4.1 About the Cine VERSUM Master Address
Common address
The common address of the Cine VERSUM Master is 0 or 1, and is selectable in the Service menu. That means that all commands
from the Remote Control, programmed with address 0 or 1, will be executed by the Cine VERSUM Master.
Individual address
In addition to the common address, an individual address can be set up in the Cine VERSUM Master, in case e.g. more units are
located in the same location. In this way, the units can be addressed individually.
The individual address can be set in the Service mode and the address number to be set depends on used control device (Remote
Control or PC).
• Addresses between 0 and 9: control device is the IR Remote Control
1
• Addresses between 0 and 255: control device is an IBM PC (or compatible), Apple, Mac, etc..
1. .
R5976468 CINE VERSUM SYSTEM 03112003 141