![background image](http://html1.mh-extra.com/html/barco/r9002040/r9002040_instruction-manual_4247218015.webp)
AC power connection
5-2
5975537 RETROGRAPHICS 808s 060197
AC Power check
The power voltage is indicated by the Art. No (Article number) on the
identification label sticked on the backside of the retroprojector.
Retroprojector with the Art. No. R9002040 has to operate on 230
Vac.
Retroprojectors with the Art. No. R9002049 has to operate on 120
Vac.
If the indicated voltage is different from that of the wall outlet, proceed
to ' AC input power voltage adaptation' (only for qualified service
technicians).
AC Input power (mains) voltage adaptation
Attention !
The
RETROGRAPHICS 808s - R9002040
leaves the factory to
operate on a mains (power) input of
230 Vac
.
The
RETROGRAPHICS 808s - R9002049
leaves the factory to
operate on a mains (power) input of
120 Vac
.
Adaptation of the power input of the projector between 230 Vac and
120Vac or vice versa is possible.
Follow the procedure as described below to adapt the voltage :
WARNING: turn off the projector and unplug the AC Power
Cord before starting the procedure !
a. Gaining access to the power selector module.
To gain access to the electronic modules of the projector, this
projector has to be turned to its service position 2. Handle as follows:
* Remove the front cover.
- open the local keyboard.
- turn both retaining screws a half turn counter clockwise.
- pivot the front panel to the front and hook it out.
Operational position
Service position 2
Access tube
unit
front side
Access
electronics
rear side