![background image](http://html1.mh-extra.com/html/barco/r9001310/r9001310_owners-manual_3824990021.webp)
Controlling
5-2
5975958 RETRO GRAPHICS 2100 210198
Projector Address
a. Software set up of the projector address.
Every projector requires an individual address between 0 and 255
which can be set in the Service mode.
Only projectors with addresses between 0 and 9 can be
controlled with the RCU.
See 'Change projector address' in chapter 'Service mode'.
b. How to control the projector.
The projector's address may be set to any value between 0 and 255.
When the address is set, the projector can be controlled now with
:
- the RCU for addresses between 0 and 9.
- computer, e.g. IBM PC (or compatible), Apple MAC, etc. for
addresses between 0 and 255.
Note : A projector will respond to a RCU set to an address of '0'
regardless of what address is set in the projector itself.
c. Using your RCU.
Before using your RCU, it is necessary to enter the projector
address into the RCU (only when that address is between 1 and
9). The projector with the corresponding address will listen to that
specific RCU.
When address 0, 'zero address' is programmed into the RCU, every
projector, without exception will listen to the commands given by
this RCU.
Plug one end of the remote cable in the connector on the bottom of
the RCU and the second side in the connector in the rear panel of
the RETRO DATA 2100 labelled '
CTRL
'.
b)
RCU used in a hardwired configuration.
PROJECTOR ADDRESS
001
$8',2287
$8',2,1&
$8',2,1%
$8',2,1$
9,'(2
9,'( 2
69,'(2
5*%+&9
5* %+&9
/5
/5
/5
/5
,5
5
5
*
*
%
%
+&
+&
9
9
72/2&$/&21752/21/<
3257
3257
3257
3257
3257
56,1 56287 &2003257 &75/
hard wire remote
2KP:
/5
How to display a projector address?
Press the ADDRESS key (recessed key on the RCU) with a pencil.
The projector's address will be displayed in a 'Text box' in the bottom
right hand portion of the screen. This text box automatically
disappears after a few seconds.
To continue using your RCU, it is necessary to enter the same
address with the digit buttons (address between 0 and 9). For
example, if the Address Key displays projector address 003, then
press the "3" digit button on the RCU to set the RCU's address to
match the projector's address. Do not press digit 003. This will
address the remote to '0' and control all projectors in the room.