![background image](http://html.mh-extra.com/html/barco/pfwu-51b/pfwu-51b_user-manual_474226063.webp)
57
9.Settings 2
9.8 Advanced 1
Menu Position
You can use this function to designate which area on the image the OSD Menu will appear.
As you can see from the diagram below, there are five positions where you can choose to have the OSD Menu displayed.The
default setting is “Center”.
UP
Center
Down
Right
Left
Translucent Menu
Press or to select OSD background translucent level.
Low Power Mode
The projector can be connected to a network via its RS232 and/or RJ45 port for remote operation with two separate boards to
control the signal source from RS-232 and/or RJ45 ports.
For complete remote operation of the projector over RJ45 port, it is recommended the "Low power mode" of OSD to be "Off"
option, even if the projector in "Standby" state.
By setting "Low power mode" being "Off" option, user would not be able o conserve power consumption in "Standby" state.
Fan Speed
Use this function to control the projector's cooling fan. You can set it to Normal or High. The default setting is Normal.
Under normal circumstances, the projector will operate normally with this function set to Normal. By default, the projector
will detect the temperature of the surrounding environment to regulate the speed of the cooling fan. When the ambient
temperature rises, fan speed will increase (generates louder noise) to make sure the heat inside the projector gets discharged
and keep the projector working normally.
However, if you were to operate the projector in environment of excessive heat or in areas of high altitude, the projector may
automatically shut down. When this happens, you can enable this function by setting it to High to force the cooling fan to
work at a higher speed to regulate the temperature inside the projector.
• High altitude region refers to area with elevation over 1500 meters (4900 feet).
• When operating in normal altitude environments, the projector will adjust the cooling fan according to the temperature of
the working environment. When the temperature rises above 30C, the projector will automatically increase fan speed.
• According to the product specification, the maximum operating altitude for the projector is at [email protected] means that
you should not be operating the projector in high altitudes when the working environment is over 25C.
(Due to the air thinning substantially at high altitudes, the result of cooling achieved by the cooling fan is significantly
reduced compared to operation on level ground. With low atmospheric pressure and high operating temperature, the
cooling fan will not be able to disperse the heat adequately)
Lamp Hour Reset
Use this function to reset the hours for lamp to zero.
After replacing the lamp, remember to reset the lamp hours to ensure the accuracy of lamp hours
displayed in the OSD Menu