Barco NW-12, Руководство пользователя

Страница: 36 / 181

4. Installation
HUB
To LAN
DVI DVI COMPUTER COMPUTER
RS 232 C RS 232 C DVI DVI R.C. R.C.
DVI DVI COMPUTER COMPUTER
RS 232 C RS 232 C DVI DVI R.C. R.C.
R / PR R / PR G / Y G / Y B / PB B / PB Hs / Cs Hs / Cs Vs Vs VIDEO VIDEO S-VIDEO S-VIDEO R / PR R / PR G / Y G / Y B / PB B / PB Hs / Cs Hs / Cs Vs Vs VIDEO VIDEO S-VIDEO S-VIDEO
DESKTOP INPUT DESKTOP INPUT
Image 4-25
Connection via a hub
See Network settings to set the communication port, "Network settings", page 32
The linking of projectors is treated in the section “Setup of the linked projectors in a multichannel system”
4.5.10.2 Network settings
What can be done?
These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current) IP Address of the projector (This is a non-adjustable value ).
Subnet Mask Subnet Mask (This is a non-adjustable value )
Gateway Gateway (This is a non-adjustable value )
DHCP
DHCP setting:
•
Yes : The projector will dynamically obtain its IP address from the DHCP server.
• No : The IP address needs to be entered manually. Note that when selecting Fixed IP
the IP settings fi elds are enabled
IP Address
Fixed IP Address of the projector : this fi eld can be edited when Fixed IP is selected
Subnet Mask Subnet Mask : this fi eld can be edited when Fixed IP is selected
32 R59770286 NW-12 25/09/2008