Barco NW-12, Руководство пользователя

Страница: 129 / 181

7. Advanced
7.9.6.2.1 Introduction
Although DynaColor can also be used in case of a single projector to force a desired color reproduction, we
will cover only the case where multiple projector have to be color matched using DynaColor.
Standard Dynacolor adjustment procedure (multiple projectors)
The adjustment of Dynacolor consists of :
1.
Measuring the color values for each projector (Calibration procedure)
2. Calculating the common values fi lling them in the desired value of every projector
In fi tec Dynacolor adjustment procedure (in the projector)
The adjustment of Dynacolor for In fi tec consists of :
1. Measuring the color values for each fi lter (Calibration procedure) in In fi tec mode
2. perform fi lter Matching the common values will be fi lled in automatically by the projector
The In fi tec Dynacolor calibration can also be done over multiple projectors. Common values must be calcu-
lated and fi lled in every projector.
In case one uses linked Dynacolor, the master projector will calculate the common values and force them on
all (the linked) slave projectors
7.9.6.2.2 Calibration for the standard mode (for multiple projectors)
What has to be done ?
The calibration of Dynacolor consists of measuring the color values of each projector. The measurements have to be done in a
dark environment. Make sure all external lights are off (even a PC screen can produce too much unwanted light). Use a light
meter (PR655, LMT, …) and at a
fi xed position during the entire measurement. In the procedure below we consider a system of 2
projectors.
C
AUTION
:
Only to be done by quali fi ed personnel ! Never change the values if not needed. Altered color
values will not guarantee optimal image reproduction.
How to calibrate Dynacolor for projector 1 ?
1. Select Set1 (see procedure above)
2. Press Calibrate in the Dialog box
A red full screen test pattern is displayed.
3. Press ENTER
R59770286 NW-12 25/09/2008 125