Barco Nio MDNC-3521 SNES, Руководство пользователя

Страница: 28 / 66

R5915130 /05 Nio 2MP / 3MP LED Display 28
4.7 Hibernate
About hibernate
When hibernate is enabled, not only the backlight, but also other functions will be disabled to reduce power
consumption to a minimum. This happens after an adjustable time-out.
DPMS mode must be enabled before hibernate can be enabled. See “DPMS mode”, page 27 .
When DPMS mode with USB charging is enabled (see “DPMS mode”, page 27 ) and hibernate is
enabled (see “Hibernate”, page 28 ), you can easily awaken your system from hibernate with a
mouse/keyboard connected to the display.
When DPMS mode
without USB charging is enabled (see “DPMS mode”, page 27 ) and hibernate
is enabled (see “Hibernate”, page 28 ), you can only awaken your system from hibernate by pressing
the jog dial, or with a mouse/keyboard connected to the workstation (and not to the display).
To enable/disable hibernate
1. Bring up the OSD main menu.
2. Navigate to the Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To adjust the hibernate time-out
1. Bring up the OSD menu.
2. Navigate to the Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the time-out value as desired and confirm.
4.8 Presence sensor
About presence sensor
The presence sensor detects if somebody is present in front of the display (within a range of approximately 90
cm) and will set the backlight to a minimum if nobody is present after a time-out (configurable in the OSD
menu by the presence sensor timer). When a person is detected, the display will switch to normal operation
again.
The presence sensor cannot distinguish the difference between a person and an object. This means
that for instance, a high chair might also be detected and could prevent the backlight to be set to a
minimum.
Changing the display position (height, tilt, swivel or pivot) might influence the detection range of the
presence sensor.
DPMS mode must be enabled before presence sensor can be enabled. See “DPMS mode”, page
27 .
To enable/disable the presence sensor
1. Bring up the OSD main menu.
2. Navigate to the Power Management menu.
Advanced operation