![background image](http://html1.mh-extra.com/html/barco/ngs-d320-lite/ngs-d320-lite_user-manual_3883334036.webp)
4. Operation
- IP address
- Subnet mask
- Gateway address
Note: The gateway must be set for proper network operation.
- NTP server address (if applicable)
- DNS server address (if applicable)
3. Press
Apply
. (refer to the Note in "WebUI overview", page 21 for more information, you may need to
scroll down for this button).
Device not found
When no DHCP server is present in the local network and the device is not con
fi
gured to Static IP ad-
dressing:
•
The device will fall back to a link-local address, e.g. 169.254.x.x
•
Any other connected device in that network segment will also have a link-local address.
•
As such, communication with the device is still possible.
•
To be able to discover the device in such scenario, see "Discovery", page 23. Use any of the methods
described there to discover the link-local IP address of the device.
4.5.2.2 Managed mode
Introduction
The
Managed Mode
is enabled by
default
, and is required for operating the device in a larger system.
("Control modes", page 7 , for an overview of the operational modes.)
Enabling this by default allows a system user to con
fi
gure all devices from a central point in the system
without
fi
rst having to go to each box individually to enable managed mode, hereby defeating the concept
of having a system.
Refer to the applicable
Barco Management System Installation Guide
to operate the device in this mode.
Select
Managed Mode
(slide the bullet to the
right
) to enable the device to be managed by the system.
Automatically discover server
•
By default, this is switched
on
(bullet to the
right
) and the device will automatically attempt to discover
the management server:
- If a management server is found, the device’s con
fi
guration is synchronized with the management
server and the device can be controlled by the management server.
- If no management server is found, the device will fall back to unmanaged mode.
•
In case you want to de
fi
ne the server yourself, switch
off
(slide the bullet to the
left
),
fi
ll in the
Server
IP address
, and press
Apply
.
Use self registration
•
By default, this is switched
on
(bullet to the
right
), and the device will automatically register itself with
the management server.
•
In case you want to register the device manually, switch
off
(slide the bullet to the
left
), de
fi
ne a
User
name
and
Password
for registration, and press
Apply
.
Manually setting the management server and the registration credentials, can be re-
quired to adhere to security policies.
34
K5903129 NGS-D320 29/09/2016