ImagePRO-II • User’s Guide
55
4. Menu Orientation
Configuring Outputs
For devices connected to the ImagePRO-II, you can read the name of the digital display
and the preferred video format that the display uses.
The
Output Auto Config
Submenu
supports
letting the output device on the DVI-D,
HD-15, HDMI, or DisplayPort connector change the output format
and the audio sample
rate
of the
ImagePRO-II
.
As the format changes, the colorspace, sample rate and bit depth
may also change. For details, refer to
Setting ColorSpace, Sample Rate, and Bit Depth
The following figure illustrates the
Output
EDID Auto Config Submenu
.
Figure 4-25.
Output EDID Auto Config Menu
On this menu:
•
The
Select Output
line shows the connector from which to read EDID
information. The default value is
DVI
.
•
Auto Config
is a command to read the EDID information of the output device,
determine the preferred resolution, and set the output format to that resolution.
Selecting
Auto Config
changes the output format of the ImagePRO-II to the
output device’s preferred resolution.
•
Status
displays a submenu that tells whether the EDID information has been
read. If it has been read, the submenu also displays the name, status, and
preferred resolution of the display device.
sáÉïáåÖ=lìíéìí=bafa=fåÑçêã~íáçå
To view the EDID information of an output display, follow these steps:
1.
On the
Output EDID Auto Config Menu
, select
Status
.
The
Output EDID Status Menu
appears, as shown in the following illustration. On
this menu, you can read the EDID information for an output you select.
Figure 4-26.
Output EDID Status Menu (sample)
2.
Use
Output
to select an output to read (
DVI
,
HD-15
,
HDMI
,
DP
).
OUTPUT EDID AUTO CONFIG
> Select Output
DVI
Auto Config
Status
>>
Note
Only the
DVI-D
,
HD-15
,
HDMI
, and
DisplayPort
output
connectors can read EDID information.
OUTPUT EDID STATUS
> Output
HD-15
Status
OK
Name
DELL E172FP
Pref 1280x1024P @60.02