20
ImagePRO-II • User’s Guide
3. Hardware Installation
Installation
Chapter 4, or by using zoom and pan settings, as described in
fåëí~ää~íáçå=oÉèìáêÉãÉåíë
To set up the ImagePRO-II, you will need the following equipment:
When connecting to an ImagePRO-II, use high-quality shielded cables.
If you intend to operate the ImagePRO-II remotely using the Web Interface, you can do so
over a wireless network. For this option, you will need a wireless router and access to a
wireless network, along with a device such as a smartphone, computer or laptop, notebook
or tablet.
fåëí~ääáåÖ=íÜÉ=fã~ÖÉmolJff
Use the following procedure to install the ImagePRO-II:
1.
Follow the unpacking procedures as listed in the
section on page 16.
2.
As required, refer to
Physical and Electrical Specifications
section on
page 168 in Appendix A for electrical and mechanical details.
3.
As required, refer to the
section on page 12 in
Chapter 2 for the locations of all connectors.
4.
If you are rack mounting the ImagePRO-II chassis, follow the rack mount
procedures as outlined in the
5. Ethernet
Connections
a.
Connect an Ethernet cable to a Switch.
b.
Ensure that the Switch is connected to a data port.
c.
Connect the Ethernet Switch to the ImagePRO-II’s Ethernet port.
6. Source
Connections
Table 3-2.
Equipment List, Basic ImagePRO-II System
Qty.
Item
Note
1
ImagePRO-II unit
1
Display device
Customer supplied
1
Ethernet Switch
Customer supplied (Optional: for web interface, Encore Controller, or
ScreenPRO-II Controller)
1
Ethernet cable
Customer supplied
1
Video cable
Customer supplied (Optional, for Genlock and Genlock Loop)
TBD
Dedicated sources
Analog and/or digital video as required (customer supplied)
Note
As an alternate method, you can use a direct Ethernet
connection or a wireless connection between the
ImagePRO-II and a web-enabled device.