Barco ILite 6, Руководство по обслуживанию

Страница: 64 / 82

A. On screen display messages
A.1 OSD messages
Some of the OSD messages listed below can be displayed on request via the XLite toolset.
List with OSD messages for ILite 6/8/10/12 tiles
OSD message Description
ACONT
100
100
100
Displaying the RGB values set for analog contrast. These values are factory pre-adjusted.
ADDR
26
Displaying tile address. Note that all devices in the data chain has an address number, starting with the
master digitizer having address “1”. The address number increments for all following devices in the
data chain. Each digitizer,
fi berlink transmitter, fi berlink receiver, AEC and all tiles in the data chain are
considered as a device with a unique address.
CALI
BRATE
BUSY
Calculating the calibration values.
CALI
BRATE
DONE
Calibration process done.
COLOR
VALUE
ERROR
Wrong measurement values stored. Tile needs to be re-measured in factory.
CONTR
MIS-
MATCH
Gives warning that LMT-saved analog contrast differs from current contrast.
DCONT
100
100
100
Displaying the RGB values set for digital contrast. These values can be changed between 0 and
255 using the XLite toolset.
ERROR
LINK
←
&
→
“LINK” signal (sync) detected from left and from right.
ERROR
NO
LINK
←
/
→
No “LINK” signal (sync) detected.
FAN
SPEED
70%
Displaying the fan speed, in percents, of the internal fan of the ILite tile.
FIRM
A1.04
B1.02
C1.20
Displaying fi rmware version of the re-sync unit (second line), fi rmware version controller (third line) and
the fi rmware version of the driver (fourth line).
60 R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007