Barco iD R600+, Руководство пользователя

Страница: 26 / 179

4. Setup
4.5 Projector address
What can be done ?
The projector is shipped with projector address set to ”0”
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu
Projector Address
, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
How to change the projector’s RC5 address ?
1. Press MENU to activate the Tool bar
2. Press → to select the
Installation
3. Press ↓ to Pull down the
Installation
menu
4. Use ↑ or ↓ to select
Projector address
(image 4-5)
5. Press ENTER
A dialog box appears on the screen. (image 4-6, image 4-7)
Image 4-5
Image 4-6 Image 4-7
Entering the new projector address ?
1. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.
This address must be between 0 and 255.
How to change the common RC5 address ?
1. Press MENU to activate the Tool bar
2. Press → to select the
Installation
3. Press ↓ to Pull down the
Installation
menu
4. Use ↑ or ↓ to select
Projector address
20 R5976874 ID PRO R600/R600+ 21/09/2006