Barco HDF-W30LP, Руководство пользователя и инструкция по установке

Страница: 63 / 311

7. Lenses
It’s recommended to place the plastic cap of the original projector packaging, back into the Lens opening to
prevent intrusion of dust.
7.5 Lens safety cable
When using the safety cable ?
The lens safety cable must be used in any circumstances to protect a mounted lens in the lens holder.
Con fi guration differences
There are two different con fi gurations for the safety cable. The con fi guration used depends on the used carrying handle or hoisting
eye.
• Con fi guration A applies when connecting the projector to the bottom carrying handle.
• Con fi guration B applies when connecting the projector to the hoisting eye.
Necessary parts
• Safety Cable (750 mm, Ø3 mm)
• Cable clamp M4
• Shackle 7x70 mm
• 4 x Cable clip (16x16 mm, Ø4 mm)
How to mount the cable
1. Paste four cable clips on the lens as illustrated (reference 1). Orient the open side of the clips towards the front of the lens.
1
2
Image 7-16
1
2
Image 7-17
2. Snap the fi rst loop end of the safety cable into one of the following clips and let the loop end point downwards.
a) Con fi guration A: Use the upper clip on the side of the cable bundle (reference 2, image 7-16).
b) Con fi guration B: Use the upper clip on the non-wired side (reference 2, image 7-17).
3. Slide the rest of the cable around the lens counterclockwise. Click the cable into every clip it passes in this loop.
Note: Make sure the cable passes between the lens and the cable bundle.
4. Slide the cable through the loop end at the beginning of the cable.
R5906730 HDF WLP SERIES 01/08/2017 59