Barco HDF-W30LP, Руководство пользователя и инструкция по установке

Страница: 25 / 311

2. General
Image 2-9
3. Remove the carton box, the inner carton sleeve and the foam around the projector. See image 2-9.
Note: The projector is still attached to a wooden plate, which is detached from the below pallet.
4. Gently turn the projector upside down to gain access to the four bolts, which secure the projector. Note that this wooden plate is
detached from the pallet.
Tip: Lay a blanket (or the earlier removed foam) on the fl oor to protect the projector housing form scratches while turning.
Image 2-10
5. Remove the wooden plate from the projector bottom, by releasing the four bolts. Use an 8 mm Allen key. See image 2-10.
6. Gently turn the projector back on its feet.
7. Remove the foam rubber around the carrying handle.
Save the original shipping cardboard box and packing material. They will be necessary if you ever have to
ship your projector. For maximum protection, repack your projector as it was originally packed at the factory.
A plastic cap is placed into the lens opening of the projector. It’s recommended to reuse this plastic cap each
time you transport the projector. This to prevent intrusion of dust and foreign particles.
2.4 HDF WLP series fl ight case
Introduction of the HDF WLP series fl ight case
The HDF WLP series fl ight case is designed to transport the HDF series projector in a safe and secure manner. The four caster
wheels, provided with breaks, and the eight handles make the HDF WLP series fl ight case easy to handle. The fl oor of the fl ight
case wagon is equipped with two small covered compartments to store the remote control and the rigging clamps. Furthermore,
three Velcro strips are attached to the bottom for fastening the power cord of the projector.
R5906730 HDF WLP SERIES 01/08/2017 21