Barco HDF-W30LP, Руководство пользователя и инструкция по установке

Страница: 131 / 311

13. Input
Image 13-34
3D status
2. Press ENTER to toggle between [On] and [Off] .
[On] : 3D activated
[Off] : 3D deactivated
13.10.3 Auto detection
About auto detection
• Automatically detects the 3D format (Frame Packing, Side-by-Side, Top-and-Bottom) on HDMI sources, based on the content
of the HDMI Vendor Speci
fi c InfoFrame (if present). For a detailed explanation of the HDMI vendor speci fi c InfoFrame, refer to
the HDMI 1.4a speci fi cation.
• Will select SENSIO ® 3D Decoder – FFC in case Side-by-Side or Top-and-Bottom mode is detected or if no InfoFrame data is
present.
• Does not support Frame Sequential modes (Single and Dual Channel).
• Is not available on other inputs (only on the inputs of the 3D input module) and will be grayed out.
Based on data in the InfoFrame and received feedback from the SENSIO ® Autodetect core, the following formats (Input Type) will
be selected:
3D format in InfoFrame SENSIO
®
Autodetect feedback Input type selected
Frame Packing NA
4
Frame Packing (FHD3D)
Side-by-Side Side-by-Side or SENSIO
®
Hi-Fi 3D SENSIO
®
3D Decoder – FFC
Other Side-by-Side (Half)
Top-and-Bottom Top-and-Bottom SENSIO
®
3D Decoder – FFC
Other Top-and-Bottom (Half)
No InfoFrame data present NA
4
SENSIO
®
3D Decoder – FFC
How to activate/deactivate
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Input → 3D → Auto detection .
4. NA:feedback from SENSIO
®
Autodetect is not applicable in thes cases
R5906730 HDF WLP SERIES 01/08/2017 127