Barco HDF W series, Руководство по обслуживанию

Страница: 49 / 337

5. Troubleshooting
Code 6036: “Board id: power backplane unknown format” (Warning)
Situation Solution
Old projector software installed.
The ID parameters of the Power
Distribution are written in a format
which is not known by the projector
software. Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from
https://my.barco.com .
Corrupt projector software. Reinstall the latest projector software.
Code 6037: “Board id: power backplane not accessible” (Error)
Situation Solution
Only the ID parameters of the
Power Distribution board are not
accessible. The ID parameters of all
other boards are accessible. Ignore this error message unless other functionality of the Power Distribution board fails
as well. If so, replace the Power Distribution board. See XXXX.
The Board ID of all other boards
are also NOT accessible. This
may indicates a malfunction I²C
functionality on the PMP board.
1. Reboot the projector.
2. Replace the PMP board. See "Replacing the PMP board", page 156.
Malfunction Power Distribution board Replace the Power Distribution board. See XXXXX.
Code 6038: “Board id: power backplane read error” (Error)
Situation Solution
Malfunction I²C communication on
the PMP board. The input boards,
the Display board and the WARP
module also have “Board id read
errors”. Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
Code 6039: “Board id: power backplane write error” (Error)
Situation Solution
Malfunction I²C communication on
the PMP board. The input boards,
the Display board and the WARP
module also have “Board id read
errors”. Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
Code 6040: “Board id: display module unknown format” (Warning)
Situation Solution
Old projector software installed. The
ID parameters of the Display module
are written in a format which is not
known by the projector software. Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from
https://my.barco.com .
Display module has invalid fi rmware. Replace the LCD Display Interface. See "Replacing the LCD Display Interface", page
161.
Corrupt projector software. Reinstall the latest projector software.
Code 6041: “Board id: display module not accessible” (Error)
Situation Solution
Only the ID parameters of the
Display module are not accessible.
The ID parameters of all other
boards are accessible. Ignore this error message unless other functionality of the Display module fails as well. If
so, replace the Display module. See "Replacing the LCD Display Interface", page 161.
The Board ID of all other boards
are also NOT accessible. This
may indicates a malfunction I²C
functionality on the PMP board.
1. Reboot the projector.
2. Replace the PMP board. See "Replacing the PMP board", page 156
Malfunction Display module. Replace the Display module. See "Replacing the LCD Display Interface", page 161.
R5905312 HDF W SERIES 24/01/2013 45