Barco HDF W series, Руководство по установке

Страница: 171 / 267

13. Projector Control
13.5 Network
About a network connection
A network connection can be made via a wired connection or via the optional wireless unit.
Overview
• Introduction to a Network connection
• Wired DHCP set up
• Wired IP address set up
• Wired subnet mask set up
• Wired default gateway set up
• Wireless network activation
• Wireless access points selection and setup
• Wireless DHCP set up
• Wireless fi xed IP address set up
• Wireless subnet mask set up
• Wireless default gateway set up
13.5.1 Introduction to a Network connection
DHCP
Dynamic host con fi guration protocol. DHCP is a communications protocol that lets network administrators manage
centrally and automate the assignment of IP addresses in an organization’s network. Using the Internet Protocol, each
machine that can connect to the Internet needs a unique IP address. When an organization sets up its computer users
with a connection to the Internet, an IP address must be assigned to each machine. Without DHCP, the IP address
must be entered manually at each computer and, if computers move to another location in another part of the network,
a new IP address must be entered. DHCP lets a network administrator supervise and distribute IP addresses from
a central point and automatically sends a new IP address when a computer is plugged into a different place in the
network.
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
Subnet mask
A number that is used to identify a subnetwork so that IP addresses can be shared on a local area network.
Default Gateway
A router that serves as an entry point into and exit point out of a network. For example, a local network (LAN) may
need a gateway to connect it to a wide area network (WAN) or to the Internet.
MAC address
Media Access Control address. Unique hardware number, used in combination with the IP-address to connect to the
network (LAN or WAN).
What should be set up for an Ethernet address?
2 ways can be used to assign an address:
•
use the DHCP setting so that an automatic address will be assigned.
• Assign manually an IP address, Net-mask (subnet-mask), (default) gateway address.
-
Set the IP-Address fi eld to the desired value. This must NOT be 0.0.0.0 for static IP-Address assignment. The IP address
identi fi es a projector’s location on the network in the same way a street address identi fi es a house on a city block. Just as
a street address must identify a unique residence, an IP address must be globally unique and have a uniform format.
- Set the Subnet-Mask as appropriate for the local subnet.
- Set the Default-Gateway to the IP-Address of the local router (MUST be on the local subnet!) on the same network as this
projector that is used to forward traf
fi c to destinations beyond the local network. This must not be 0.0.0.0. If there is no
router on the projector’s local subnet then just set this fi eld to any IP-Address on the subnet.
R5905158 HDF W SERIES 10/07/2012 167