Barco Galaxy 12 High Brightness+ R9040370, Руководство пользователя

Страница: 41 / 173

4. Connections
4.7.2.2 Single CADWall Configuration
This chapter will describe the Stereo Connections for e.g. a Triple-Channel CADWall Setup.
How to connect the Stereo Signals in a Single CADWall Configuration?
1. Connect the Stereo Sync Signal coming from the IG to the Stereo In Mini DIN Input of all the projectors used in the Multi-Channel
Configuration. (image 4-8)
Note: On some IG’s, the Stereo Sync is already present in the Vertical Sync Signal.
Note: On some IG’s, the Stereo Sync is added to the Vertical Sync Signal.
2. Connect a ’Phased L/R Signal’ BNC Connector of the first projector to a ’Phased L/R Signal’ BNC Connector of the second
projector.
3. Continue until the Phased L/R Signal is connected ’Looped Through’ to all the projectors of the Multi-Channel Configuration.
4. Connect the ’IR Emitters to a free ’Phased L/R Signal’ BNC Connector.
All projectors will run on a common Stereo Sync (Phased L/R) Signal.
All Stereo IR Emitters will work in sync.
High Bandwidth RGB INPUT
Projector 1
DVI INPUT
L/R SIGNAL Phased L/R SIGNAL
IN OUT
G R B H/C V
High Bandwidth RGB INPUT
Projector 2
DVI INPUT
L/R SIGNAL Phased L/R SIGNAL
IN OUT
G R B H/C V
High Bandwidth RGB INPUT
Projector 3
DVI INPUT
L/R SIGNAL Phased L/R SIGNAL
IN OUT
G R B H/C V
IR Emitter
Active Glasses
IR Emitter
Image Generator
CadWall
Image 4-8
Stereo Signal Connections in a Single CADWall Configuration
R5976780 GALAXY SXGA+ SERIES 14/10/2005 37