Barco Galaxy 12 High Brightness+ R9040370, Руководство пользователя

Страница: 24 / 173

3. Installation Guidelines
3.7.5 Lens Installation
How to install ?
Follow the next procedure:
1. Remove the foam rubber in the opening of the lens holder.
2. Take the lens assembly out of its packing material and remove the lens caps on both sides.
3. Move the handle (A) of the lens anchor system to the right. (image 3-10)
4. Push the lens, motors at the top, in the lens block gap horizontally, lining up the motor connector on the lens with the connector
on the lens block (B), until the lens clicks in the lens anchor system. (image 3-11)
Caution: On a table mounted projector, hold the projector when pushing the lens into the lens block to avoid sliding off from
the table.
Image 3-10
Lens installation
Image 3-11
Mounted Lens
3.7.6 Lens Adjustments
Overview
• Scheimpflug Adjustment
When performing a Lens Adjustment, lens Adjustment patterns can be generated within the Installation menu.
3.7.6.1 Scheimpflug Adjustment
Overview
• Scheimpflug Adjustment Overview
• Scheimpflug Locks
• Top–Bottom Scheimpflug Adjustment
• Left-Right Scheimpflug Adjustment
3.7.6.1.1 Scheimpflug Adjustment Overview
Why performing the Scheimpflug Adjustment?
Scheimpflug Adjustment is needed If an image is still unsharp, even after the focus adjustment.
This means the image lies in a plane which is not parallel to the screen plane, as the deviation between the image plane and the
screen plane can be in both the Top-Bottom and Left-Right directions, it is necessary to proceed in two distinct steps in following
order).
20 R5976780 GALAXY SXGA+ SERIES 14/10/2005