Barco G62, Руководство пользователя

Страница: 32 / 124

R5914653 /02 G62 32
to the same number. The default ID code of the RCU (also known as the broadcast address) is 00. This
specific address allows the RCU to control all projectors within its effective range.
How to set the projector address on the RCU
1. Keep ID Key pressed in.
2. After few seconds, enter the address with the numeric keys while keeping the ID Key pressed in.
Tip: Always enter two digits. E.g. for address 2, enter 02.
3. Release the ID Key .
The projector address can be set in: Communication > Remote setup > Remote code .
4.4 Using the RCU
Effective range
The Infrared (IR) remote control sensors are located on the front and top sides of the projector. To have the
remote control functions correctly, make sure of the following:
• The maximum range between the remote control and the sensor is 30 m (98.4 ft).
• Ensure to hold the remote at the following angles towards one of the IR remote control sensors:
-
horizontally: ±30°
- vertically: ±20°
• Make sure there are no obstacles between the remote control and the IR sensors on the projector.
• Make sure the IR transmitter of the remote control is not directly being shined by sunlight or fluorescent
lamps.
• Keep a minimum distance of 2 m between the remote control and nearby fluorescent lamps. If not, the
RCU might malfunction.
• If the projector and remote are within very short distance, the RCU may become ineffective.
• When you aim at the screen, the effective distance is less than 5 m from the remote control to the screen
and reflecting the IR beams back to the projector. However, the effective range might change depending
on type of screen used.
Remote Control Unit (RCU)