- 3 -
Installing the RCU batteries
1.
Remove the cover by sliding it in the direction indicated by the arrow.
2.
Insert two new AAA batteries (observe the polarity).
3.
Reinstall the cover.
1
2
3
CAUTION: Replace batteries with the correct battery type. Use AAA size batteries. There is a risk of
explosion if the batteries are replaced with an incorrect type. Make sure the polarities match the +
and - marks, as depicted on the inside of the battery compartment. There is a risk of explosion if the
batteries are installed incorrectly. Use alkaline batteries for optimum range and life time.
Batteries are not included in the packaging. It is up to the user to purchase the correct batteries.
Installing the lens
1.
Remove the lens cap. Release the lens by turning it counterclockwise and pulling it outwards.
Warning:
Lens cap should be removed before installing the lens. If not it will damage the projector.
2.
Gently insert the lens in the lens holder. Ensure that the label
“
TOP
”
(reference T) is upwards oriented while
inserting the lens.
3.
Rotate the lens clockwise to lock the lens.
1
2
3
T
CAUTION: Do not transport the projector with any lens installed.
How to power on the projector
1.
Connect the projector with the power net as follows:
a)
Ensure that the AC switch (reference 1) stands in the
‘
0
’
(OFF) position.
b)
Plug in the mains cord in the power input socket of the projector.
c)
Connect the other side of the mains cord with the power net.
d)
Power on the AC switch (reference 1) and wait until the POWER button on the control panel is solid
red.
