Date: 22/09/98 R808293K - R809419K
LCD Panel Replacement for G2100 series
5
Service Instructions
R808293K
R809419K
LOCKING
NUT
RIGHTSIDE
BRACKET LOCKING
SCREW
RIGHTSIDE
BRACKET LOCKING
SCREW
a
The two (rightside
a & leftside
b) bracket locking
screws must be hand un-tightened to release the projector
from its locked position. Once this is done the projector
must be rotated on its attached brackets from its now
operating position to the horizontal slide out position either
in the clockwise (
b) or counter clockwise directions,
dependant on front or rear removal, remember it is still
necessary to remove the
right audio
speaker if choosing
to remove from the front side. Exercise caution during this
procedure as the projector requires to be nudged slightly
(just a couple of centimeters, but ensure the brackets are
never in danger of leaving the slide rails) backwards or
forwards to facilitate rotating and avoiding obstructions to
the lens. The projector can now be pulled out and lifted
clear of the cabinet.
a The hand tightable projector bracket locking screws
must be undone before the projector can be rotated to the
horizontal exit position, it may be necessary to loosen the
locking nuts slightly to facilitate un-tightening the bracket
locking screws.
725(029()5205($5
725(029()520)5217
23(5$7,21$/
326,7,21
5(029$/
326,7,21
23(5$7,21$/
326,7,21
5(029$/
326,7,21
b
OUT
OUT
Ü
Û
A
B
C
A
B
C
b Access will be available to remove the projector
either from the front or the back dependant on the
direction of rotation.
Note:
Extra care must be observed not to damage or
scratch the projector lens during the rotating process.
PROJECTOR
REMOVAL POSITION
FROM REAR
ê
The projector can be removed from the rear (rear slide
out position) by pulling and gripping firmly until it is fully
out. Gently place the projector on a solid stable surface.
Warning: Projector is heavy
.
