![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029114.webp)
114
FSN Series • User’s Guide
4. Installation
Signal Connections
råáîÉêë~ä=fåéìí=`çååÉÅíáçåë
The figure below illustrates universal input connections on a
UIC
’s I/O panel:
Figure 4-19.
Universal input connections
Use the following steps to connect universal inputs to a
UIC
.
1.
Using an HD-15 cable directly, or an HD-15 to 5 x BNC breakout cable, connect
the desired analog input to the
Universal Input 1, Analog
connector.
2.
Using a standard DVI cable, connect the desired digital input to the
Universal
Input 1, Digital
connector. The connector accepts digital signals only.
3.
Using a BNC cable, connect the desired SDI signal to the
Universal Input 1, SDI
connector.
4.
Using an HD-15 cable directly, or an HD-15 to 5 x BNC breakout cable, connect
the desired analog input to the
Universal Input 2, Analog
connector.
5.
Using a standard DVI cable, connect the desired digital input to the
Universal
Input 2, Digital
connector. The connector accepts digital signals only.
6.
Using a BNC cable, connect the desired SDI signal to the
Universal Input 2, SDI
connector.
Please note the following important points:
•
You can connect three signals to
UIC Input 1
, and three signals to
UIC Input 2
,
but you can only use one signal at a time for each input. However, you can also
store setup files for different input combinations, and recall the desired setup to
Universal Input 1, Analog
Universal Input 1
Universal Input 1, SDI
SDI
An
al
og
D
V
I D
ig
ita
l
A
n
a
log
DV
I Di
g
it
a
l
2
1
Universal Input 2, SDI
Universal Input 2
Universal Input 2, Analog
Digital only
Digital only